Keychain Assembly Guide

Assembly instructions 

1. Put the ashes, fur, etc., into the vial.
2. Insert the cap with the rubber o-ring into the glass vial at an angle. Gently twist the glass vial into place.
3. Place the cap and glass vial into the urn and line up the holes.
4. Place the key-ring loop over the center of the cap and urn, and ensure the holes are lined up.
5. Insert the pin through the hole on each side of the loop/urn/cap -- Make sure the pin is centered between the loop arms.
6. Using pliers, gently squeeze one of the loop arms just above the pin hole to tighten. Repeat on the other side. This will permanently lock the urn assembly into place.